Draftsight 2016 freezes3/21/2023 ![]() And then, after all, the hatch command was able to make the hatch. And I was able to make a polyline from it without problems. But today I decide not to do it" To the example mentioned before - Just for fun I deleted all the lines that are no boundaries for my desired hatch. It is like AutoCAD would say: "Okay, I could make a hatch for you. No possibility to generate a hatch but the preview (when I hoover the crosshair) works fine before. ![]() Today I tried to make a hatch in an area sourrounded by lines and arcs. Thank you for your accurate summary of the fact, that AutoDESK was not able to program a hatch command that works reliable even on difficult geometry (and sometimes very simple geometry) since 1989 (the year I bgan to work with AutoCAD. Check it out if you're ready for a drastic change in subject material. I hope you all enjoyed, and feel free to leave any more ideas in the comments section.Īlso, and unrelated, I also write theology for the blog. This will look terrible and cause its own set of problems, but if the board meeting is in 5 minutes and nothing else is working, this might just get you through, and look slightly better than filling it in with a Sharpie marker.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |